Finally done!  Mercury Magnetics trannies, Walnut and Flame Maple cab, Maple face-plates with Walnut and Abalone inlays, custom knobs.  Yummy!

What should the voltage be at P and Q?

I'll get a detailed scenario together tomorrow.  I think I may have a bad switch, relay or both.

Roger

I built this kit and am having issues with it.  I have checked the wiring many time and it all seems OK but I still have some problems and would like to check out a fully working amp to compare with mine to see where I may have mucked this up.

Roger

Thanks for this post, Dennis.  I was going to ask this same thing.

Roger

mcinku,


Don't you have some pix of that mod from your build?

Roger

Blues:  I make custom guitar knobs and other stuff out of wood so I have a thing for custom wooden goodies.

Hywelg:  LOL!  This amp will never leave my house.  Well, maybe to go to the studio. 

Once I get the cabinet, I may make  yet another set of plates.  This one in Walnut.  We'll have to see when the cabinet arrives.  This amp will have all custom wood knobs on it, too.  Maybe I'll even make a wooden cable!  If I could only get it to pass current.

It will look similar to this cabinet.

I need to choose one of these faceplates for my amp.  It will be housed in a Flame Maple and Ribbon Walnut cabinet.

Which would you choose?

If you go to YouTube, there is a guy called marinblues (I have seen him in these forums) who has clips of the OTS and the OTS HRM that are pretty cool.  1 video, in particular, has them side by side for comparison.  I think it is called "
To HRM or not to HRM."  I'm not sure if there are any clips of the Bluesmaster version yet.

Oops.  There are a few numbers I added but will have to create a new jpeg for them.  For now, the holes on the front and rear bends are 1.8125" from the sides and the holes in the side bends are 1.5" from  the front and rear bends.  The distance from front to rear bend holes is 7.1875".  Also, the 18.75" measurement from left side to right side hole is actually 18.4375" from center to center (at least on my chassis.  JUST BE SURE TO DOUBLE CHECK THE MEASUREMENTS AGAINST YOUR CHASSIS BEFORE HAVING A CABINET MADE.

Hope this helps.

Roger

Sure.   He did say to double check the measurements because the bend lines on the chassis may vary slightly.  Also note that the measurements are very light and do not really appear very well until you print out the jpeg.

Yep.   got them from Nik.

Thanks again.

Roger

Thanks!  The only thing missing is the hole pattern for the mounting screws.  Do you happen to have those, as well?

Roger

Does anybody have the specs needed to give to a cabinet builder to house the OTS chassis?

Thanks!

Roger