Buzz when Bright Switch off

jhyatt2012
Newbie

Offline

Posts: 9

« on: March 07, 2012, 10:54:02 PM »

I've just finished my OTS build and it sounds amazing! I do have two issues though.

1. When toggles are set to bright=off deep=off and rock=on, I get a horrible buzz in the clean until I dime the preamp volume. When the preamp is on 10 the buzz goes away. No noticeable buzz in the overdrive.
2. I get a pretty good hiss in the distortion regardless of my settings.Y

Ive checked solder joints and everything "looks" to be ok. I'm a total newbie and this is my first build so I'm learning.


	Logged

SoundPerf
Sr. Member

Offline

Gender: Male

Posts: 392

Re: Buzz when Bright Switch off

« Reply #1 on: March 08, 2012, 08:17:09 AM »

I would double check all the wiring in the first stage of the of the preamp and around the switches and proper component placement. And probably first, make sure that the level pot is good.

When you say you are a newbie. Do you mean newbie to amp building to newbie to electronics and soldering in general? What are the chances tht you overheated a pot or switch? And then OTOH a solder joint can look mechanically good but be cold.


	Logged

Chris

Ceriatone HRM 50
w/self built Dumblelator
Avatar 2X12 w/WGS ET-65 & Veteran 30
TC Electronic 2290
2001 PRS McCarty
2010 PRS 513 Swamp Ash
Tacoma JK50C
Seagull S12+

jhyatt2012
Newbie

Offline

Posts: 9

Re: Buzz when Bright Switch off

« Reply #2 on: March 12, 2012, 06:25:55 PM »

Newbie to amp building, but not soldering and electronics. Have a way to go in the amp building. Re-wired some of the pots (including the preamp volume) this weekend. I had to substitute some of the RG174 on a couple of the pots. Newbie mistake #1 - had originally wired the grounds on the RG174 jackets incorrectly. Got new cable in, rewired the substituted cable with the new and Voila! Problem solved. I had considered overheated toggle switches too, but they were ok. Thanks for the reply.


	Logged

SoundPerf
Sr. Member

Offline

Gender: Male

Posts: 392

Re: Buzz when Bright Switch off

« Reply #3 on: March 12, 2012, 10:47:12 PM »

Glad to hear it!

Sounds like you're on your way. Simple mistakes are always PITA. Wink

The other day I was repairing a effect pedal and the LED indicator was relying on getting it's ground from a mechanical connection that only is connected when the pedal is put together. I wasted a good 1/2 hour until the palm to the forehead.


	Logged

Chris

Ceriatone HRM 50
w/self built Dumblelator
Avatar 2X12 w/WGS ET-65 & Veteran 30
TC Electronic 2290
2001 PRS McCarty
2010 PRS 513 Swamp Ash
Tacoma JK50C
Seagull S12+

Pages: [1]

« previous next »

	Welcome, Guest. Please login or register. Did you miss your activation email? December 24, 2024, 01:04:32 AM

News: Ceriatone Forums are up and running!!! Guests please register Note: If you want to help you can to keep the forums alive. Do you want to advertise on this forum ? Send me a private message.