Noise and buzz

achim1
Newbie

Offline

Posts: 30

Noise and buzz

« on: October 01, 2010, 10:50:08 AM »

Hi everyone,

I'm quite new here, and first of all I got a question, hope you can help

I just bought a used Overtone 50W (non hrm), and I must say I'm really happy with the tone the amp makes! I'm using also a kleinulator in the FX-Loop.
My problem now is: The amp is really noisy and buzzy, especially in the overdrive-mode. It's really loud! It has nothing to do with the kleinulator. The noise is quite there when I plugged off the kleinulator from the amp.
Could anyone help please?
Thanks and regards from germany!

Achim


	Logged

boldaslove6789
Sr. Member

Offline

Gender: Male

Posts: 310

I'm never too loud, HAHAHA

Re: Noise and buzz

« Reply #1 on: October 01, 2010, 08:07:01 PM »

Does it make the same noise when there is no guitar plugged in ? Also would you say it was a hum or buzz (If that makes any sense)? Checked all cords ( guitar cables and speaker cables) Have you swapped preamp tubes? If not find one that you know works and swap tubes 1 by 1 until you've either narrowed it down to a faulty tube or not.

I know these questions may seem rather obvious but usually all signs point to a simple problem that until you rule it out you can't completely say otherwise, just sayin..


« Last Edit: October 01, 2010, 08:09:03 PM by boldaslove6789 »	Logged

-Greg D. Clark

Stop searching for tone, INVENT IT!

http://www.funkymunkpedals.com/
Pedals That Speak!

http://www.youtube.com/GDClarkProject

ampkits
Administrator
Sr. Member

Offline

Posts: 325

Re: Noise and buzz

« Reply #2 on: October 06, 2010, 06:49:08 AM »

Hi

If the amp was a kit, check first if the wirings are alright.

But usually, its got to do with settings. The OD trim might be too high, perhaps, and you try to run it with the OD controls too high.

If the OD controls in front are set to very high, you'd have noise.

And testing the amp with you too close with the guitar, that'd bring some noise too.

Maybe try with the controls at 12 o clock first, see how that goes.

And of course, prelims like how the amp is biased should be checked. Do check out the manual thats on the website?

Thanks!

Nik


	Logged

Pages: [1]

« previous next »

	Welcome, Guest. Please login or register. Did you miss your activation email? November 24, 2024, 05:12:00 AM

News: Ceriatone Forums are up and running!!! Guests please register Note: If you want to help you can to keep the forums alive. Do you want to advertise on this forum ? Send me a private message.