Finished wiring and checking all against the layout... I am waiting for my tubes and I am building a current limiter that uses a light bulb to aid in the start-up process. I can't stress enough tracing all the wire and component runs against the layout when complete. I found 2 missing wires and 4 wires soldered to the wrong post or crossed with other wires..

I don't have a lot of amp knowledge and can someone tell me does this design have the resistors that bleed off the power caps when shutting the amp down and where are they located well after I get her started I will let all know how it went....

Build went together good.... a lot of fun... I am on vacation until 7/3 and my tubes should be waiting when I get home.. I will let you know in a couple of weeks...I can't wait..

They supply all the wire you need except the buss wire (solid wire connecting jacks) I used 22g solid hook up wire for the buss I just stripped it to the bare wire. The smaller guage wire I supplied which is 22g teflon coated high heat hook up wire.. I did not use the supplied shielded wire. I fabricated the 2 white thick wires that run from jack to pots from 2 conductor shielded cable. But they supply enough except the said buss wire. I just chose to change a little.

Just as long as your iron gets hot enough for the romex you should be alright.. if you want to go the route with the 2 conductor shielded wire let me know and I will give you the source..... any questions you can get me at snookfam1@verizon .net

don't know if your in the USA but if so you can go to Radio Shack and buy a spool of buss wire for the jacks......