 Show Posts
|
|
Pages: [1]
|
|
1
|
Ceriatone / Overtone / Re: footswitch and pab and od switches not working
|
on: February 25, 2010, 01:08:55 AM
|
|
Yep that was it.Now heres the funny thing,with no pedal installed the amp doesnt work unless the switches are on pedal(i realize this could just be the switches wired wrong) but with the pedal installed on pedal I get nothing from the amp unless I crank it and then its stilll barely nothing but if I engage the pedal it works fine.So basically it only works with the pedal engaged so i cant have a nice clean setting and then hit the pedal any idea's?sorry for the long ramble,thanks
|
|
|
|
|
3
|
Ceriatone / Overtone / Re: footswitch and pab and od switches not working
|
on: February 21, 2010, 02:24:23 PM
|
|
Jubeman,thanks.Ive rewired everything with no results.Ive got 16 volts dc to the left side of my voltage reg.middle is ground and nothing on the right side(that supplies the relays).Also no voltage to my relays whatsoever.Could i have a bad volt. reg.?
|
|
|
|
|
4
|
Ceriatone / Overtone / footswitch and pab and od switches not working
|
on: February 21, 2010, 02:52:40 AM
|
Hey guys its been a while but I've finally had some free time to try and solve this problem,but to no avail.To recap the amp works(all the pots ,the bright,deep,rock/jazz switches)and sounds great.But I cant get anything from the rear pab and od switches or the footswitch(no clicks,lights,ect),I checked all my voltages and they are spot on,and I did bias her.When I check the voltage to the small board next to the pt that the 6 volt wires go to I am getting that, and Iam assuming I should be getting that to the 2 wires that go to the footswitch connector,but Iam not?Also there are no voltages present on the relay boards either,but anyways anyone with some ideas?,thanks in adavance  |
|
|
|
|
5
|
Ceriatone / Overtone / Re: newbie with question
|
on: November 21, 2009, 03:23:47 AM
|
|
hywelg,thanks for the reply's.If I take out the relay closest to the board i dont get anything at all.I cant take out the other relay unless I remove the switches.Also where do I check for the 12 volts?Iam so excited to get this thing right,I've been playing it and it sounds absolutley fantastic,but I cant wait to get the pedal,and overdrive,ect. working.Any more suggestions?
|
|
|
|
|
7
|
Ceriatone / Overtone / Re: newbie with question
|
on: November 15, 2009, 04:44:04 PM
|
Its easy to confuse the wiring of the rear switches and socket and get them the wrong way round. Check against the pics on the site.
Also check you've got the relays the right way round.
Thanks, the relays are the little orange thing,correct?I have them in with the lettering facing the pots,from what I've seen in any pics those are right.After I biased it I noticed if I adjust the OD trim pot all the way clockwise I lose all volume,is this normal? Also if I turn the overdrive or ratio knobs all the way down I lose volume,do these things seem right?,thnaks
|
|
|
|
|
8
|
Ceriatone / Overtone / Re: newbie with question
|
on: November 15, 2009, 12:58:21 AM
|
Hey guys,just finished my ots,and it sounds good,and all the knobs do what they should,but I dont get anything from the rear toggles or the footswitch and it doesnt seam like Iam getting near enough power(volume) from it,any ideas?.I did use a hammond OT and choke,thanks in advance Alright,I found the volume level problem(this thing is loud and sweet) so now the only problem is the PAB and overdrive switches dont work or the pedal(they dont click,light up,nothing).Other than this it seems fine.Any ideas? |
|
|
|
|
9
|
Ceriatone / Overtone / newbie with question
|
on: November 14, 2009, 05:37:49 PM
|
Hey guys,just finished my ots,and it sounds good,and all the knobs do what they should,but I dont get anything from the rear toggles or the footswitch and it doesnt seam like Iam getting near enough power(volume) from it,any ideas?.I did use a hammond OT and choke,thanks in advance |
|
|
|
|
|
to keep the forums alive.
,is this a radio shack part by any chance? I cant wait to get this baby working right,thanks again