Issues resolved. Thanks everyone

OK, THIS IS WHERE WE STAND, The amp is functioning properly,and sounds good, BUT, THERE IS NOW A HUGE HUMM. the initial issue was the presence not working, I missed hooking together pins 8 & 3 on the 3rd pre tube. now the presence is working but there is a huge humm, I tried using the presence layout on the Expression and it voice is a bit different but the huge hum is still there. I don't have much experience with amp building but I'm RALLY REALLY SMART, so I bet I can figure this out. All help will be appreciated. I will post pic tomorrow   

Ok, reversing Brown and Blue worked. Presence is now working as well. Is there possiably something reversed B4 this that would account for the reverse issue? The hum issues are still a problem but the overall sound of the amp is pretty good, so, were getting close. THANKS FOR THE HELP!!!!!

The Latest. Ok. Found a mistake. I forgot to jump between pins 3 and 8 on the pre tube, but when I do that the amp takes off with what sounds like an oscillation. VERY LOUD. It i then disconnect the presence from the OT. It now is very noisy with allot of gain....    ??  I have tried this with both methods of wiring the presence, (Expression and Liverpull)  Hummmmmm.

I just put it together. The tubes aren't even burned in yet. I'm so far pretty happy with the way it sounds but there will be a bit of tweaking however. My first objective is to fix the presence and reduce the hum. a couple of other comments on what I want to achieve. I would like the amp to clean up a little quicker when I roll off the volume on the guitar and maybe a bit cleaner overall. I will be experimenting with tubes, but I would like to get as much out of the amp first. I use most of my amps for recording so hum is an issue. Thanks ahead of time to anyone that can help.

Also some hum issues. ? Anyone got any ideas?

Amp sounds good but the presence does not seem to be working. The amp is really bright! The presence would be a very good feature to have right now.  Does anyone have any suggestions for trouble shooting this issue?