Glad to hear it, I've got a G-sharp and g-switch arriving this week!! I thought I might have to get a K-ator.

Please post some pics when you've done it, if I end up going for a K then it will have to go into a rack mount unit.

Thank you for your kind comments. I did indeed make the cabs myself. The speaker cab belongs to a Fender Twin that I split into a head and speaker cab, though it sits very low to the floor and  I'd prefer something taller so I've got a vertical 2x12 being made at the moment which will replace that one soon. That will have a EVM-12L and a Vintage30 in it. I would also like another OTS to put in a combo but I really will have to sell some of my other amps first!

Other have reported here that the g-sharp works well in the loop without a Kleinulator. I hope thats true since I now have one on order, should be here this week sometime!. I was considering a BBE sonic maximiser but maybe not now, especially if its not so good on the OD channel and you can't footswitch it.

I built my own OT from Niks kit and there wasn't anything like that in there. Get the OT back out and if it came from there you should still see the other end of the wire still attached to something. Same with Kleinulator.

Was? did you cure it? I'm thinking of getting one of those myself.

Thanks

Hywel Harris

Really not necessary. I don't think Nik even balances the PI tube before sending an amp out, I think he just sets it to 12 o'clock. My amp tech set mine with a scope but said if I change the tube it'll be fine and not to worry about it.

I guess if the amp is ON standby then its OFF is you try to play anything. Simply put, if both switches are down, when standing in front of the amp leaning over, pull the right hand power switch UP first followed by the right hand StandBy switch a minute later.

No there isn't, but you'll get loads of info here, just ask away.

Cheers

Hywel Harris

Based on a couple of guys reports on these forums, I've got a g-sharp arriving next week. Won't get chance to try it at rehearsal volumes for a week or two though. Will report back when I have.

Not pre-amp tubes, no.

You can use any brand of valve. Some have different audio properties than others

Based on whats been noted here I'm going to try every variant of the 12a_7 series in V2. I've currently got a 5751 in the there and prefer it to a ax7. Maybe an ay7 will be better still! I'm very glad I moved the OD trimmer to the rear panel, It really would be a pain taking the chassis out of the case very time.

I'm aware that CorelDraw produces PDF's, however a PDF won't allow you to turn off layers one by one. As a PDF it shows way too much information, its a mess, in Draw you just turn off those layers you don't need to see. I need to turn it into a multipage document rather than a multi-layer document in order for the PDF to be readable. When I get time........

BTW the correct way to convert to PDF is via the Publish To PDF from the file menu. There is no PDF option in the Save As drop down, hasn't been since at least v12, maybe earlier.

I can send you a TR style head plan, but its a CorelDraw document. Never did get around to reworking it as a PDF. If it any use PM me.

Cheers

Hywel Harris

Plus one of the back. Two mods, FET and OD trimmers moved to rear panel, Footswitch connector changed to 5 pin XLR