HHMM,checked the resistors,and Iam getting 128 ohm's on both high and low. But the switch is def. working as you can tell from the difference in sound/volume when its switched? Probably a stupid question,but if you are looking at the ceriatone layout,is the "O" on the hi/low power switch on the bottom or top of the switch?

Wyatt,do you think not having the #9 pin coming out of the said tube would do this?    After checking out the inside of the chassis,I went to put that tube back in and noticed that. Tried a new tube(although not a matching one) and the issues have gone away,I will check out the ohm's on the resistors you mentioned,as the switch is still working like it did. I think I'am done with J J's, many thanks

Well got home and had a chance to mess with her. Before I did anything I swapped out tubes,this helped dramatically(but still had a small glow).Also when I was tinkering last night I had it on half power,so I switched it to full power today and that takes away any glow at all,and everything's working as it should (also had a brand new bad jj ef86). So I only get the glowing (no where near as bad as last night) when its on low power? I did notice my hi/low power switch is wired upside down, as when its switched to the low setting(going by the face plate) its actually the hi setting. The hi/low switch works as it should,it just doesn't correspond with the face plate. Is the small glowing normal when on the low setting,possibly?

Wyatt,thanks. I will check the voltages tonight. Yes I always do my builds stock first.It was late, so I didn't even swap out different tubes. Would the copper cap effect anything,doesn't that give you a higher b+?

Hey Guys,just finished my dizzy 30 kit last night. After fire up the second power tube,from the right (looking at the amp from the front) is red plating,gonna spend some time looking at it tonight,but any suggestions where to look first,to save me some head scratching? Also might add that I didn't have the rectifier tube/s on hand but did have the Weber copper cap gz34 solid state equivalent,would that have anything to do with it,and also if you can use the 2 5v4's,or the 1 gz34 does it matter which socket the 1 gz34 would have to go in,it doesn't appear it does,but? ,thanks in advance   

Hey Guys wheres all the post's? Anyways just got my 36 watt ef86 kit w/out trannys and was wonderin if any one has some recommendations on a set,or any recommendations,tips,etc. with this model?thanks