Hello there!

Help me with opinions how important the pin voltage is..?

I measured slightly lower on V1 pin1 - cca 176V and a tad higher on V2 and V3 than some other members here (>200V on V2 and >300 on V3).
Also pin 3 on both 6L6 is about 460-470V.
I measured the input voltage also and it's 230V rather then standard 220V (the tap I am using on trafo).
I biased the tubes to 36mV.
Is there anything I should take care off, or just Shut Up And Play My Guitar

Thanks!

Interesting..., here's an article from  "General Guitar Gadgets":

________________________________

Again, Audio taper is the same thing as Log taper. The two terms are interchangable.

The taper of a pot is designated with a letter stamped onto the back (or side, or front) of most pots. WARNING: the "A" & "B" designations are not the same worldwide! The designations that I know of are these:

In USA

    * A - Audio or Log taper
    * B - Linear taper
    * C - Reverse Log taper
    * G - Graphic taper

In Europe

    * A - Linear taper
    * B - Audio or Log taper
    * C - Reverse Log taper
    * G - Graphic taper


__________________________________

Hey, am I missing something?

I received my Overtone kit few weeks ago (fully unassembled) but there is no footswitch included.
I checked the Ceriatone site, and yes, there's footswitch included with every kit option.
Is that something recently added? Can I order footswitch extra?
I better contact Nik, then..

Thanks

It looks like this amp is useful even on bedroom levels then? Without power brake or attenuation?
Ooops, sorry I am using this thread for comments and not for sharing settings.. will stop now

Hey YOGA64, good news for me then - I have the same cheap 1x12 cabinet.
I am very happy you found this combination so satisfying.
But I didn't assemble my Overtone yet so when it's done I'll share my experience.
Really, this cabinet looks rather good considering the money!

Any experience with Tube Amp Doctor - ToneBone (Pentode or Triode)?

I wonder how these would sound in Overtone ....

Hi everyone!

I am new here so big hello to growing Ceriatone forum!
Right in the middle of assembling my Overtone, inhaling solder fumes, here's the question:

How do you bias the output tubes, what values do we looking for?

Thanks,

Fred