|
Title: OTS50 FM ME OD Question AND Midi Switching Tail? Post by: Kevster on February 10, 2019, 04:15:57 PM Hello all!!! Two quick questions... Well, after a set-up...
I have an eight year old OTS50 FM ME. I got it built and added the tubes and transformers, built the cab (two slots: Power Conditioner and C-Lator), and it is fed by a midi switcher, a few pedals, and is used for Country, Rock, and modern Praise & Worship. Amazing tones on the clean, but the OD is just not as creamy as I'd like. I know, it's got the ME mod to make it a tad more aggressive, but it is TOO aggressive at this point. I run the trim at 9:00, the Ratio at 9:30, and the Level high enough to balance with the clean. I keep the MV at about 4, and Volume at 5-8 depending on the vibe of the day. Use the C-Lator as the effective volume. Every setting imaginable has been tried. There just isn't creamy in there. More ratio/less level makes it muddier but also far grittier and harsh. I try various volume and tone settings on either a LP and a Tele, and it never gets CREAMY. Not horrible tone, but just too hyper aggressive. So, the questions: 1. Any luck with switching to an AU7 or AY7 to make a creamier OD, or some other suggestion? 2. Adding to the issue noted above that I rely on midi in many venues, and I find that I don't use the OD channel much at all anymore. I know that my GCX switcher will switch the OD/PAB with the right tail. Anybody making these tails? If so, where can I pick one up? With me living in a condo now, I don't have the ability to work on things like I used to... With the switcher, I need to split the connector 5-P connector to two 1/4" male TS with about 3' of length. Many thanks in advance!!! Kevin Title: Re: OTS50 FM ME OD Question AND Midi Switching Tail? Post by: Kevster on February 10, 2019, 04:45:43 PM Oh... and I have a EVM-12L Thiele cab.
Thanks again! Title: Re: OTS50 FM ME OD Question AND Midi Switching Tail? Post by: Kevster on February 08, 2020, 07:31:28 PM Hello All,
I grabbed a Din-5 Y-Cable for switching channels on my OTS FM50ME and using my GCX Controller. I connected it to the amp and the "Out" or "Send" of two channels on the GCX as in as directed, and.... NADA. Neither NO/Out or NC/Send bumps the channels in any way. Nik said that my amp channels are NOT Momentary, so I figured I'd go to the well and see if anybody was able to successfully use a switcher to switch the channels on their Ceriatone. It could be the wiring of the Y-Cable, but I was going to ask around before I dissected the cable. Anyone have an experience with this and their Ceriatone? Thanks!!! |