|
Title: Is it just me? Post by: djroge1 on August 22, 2009, 04:45:19 AM I'm about to hook up the power transformer and all of the wire colors seem reversed and the label is no help at all.
According to the wire diagram the side closest to the pots (presence, master etc) has 8 wires while the other side has 7. All of my color wires are the opposite of the pics on the web site. Is it me or have any of you had this same problem? Do you think it's safe to assume the 8 vs. 7 wires to determine what goes where? This and the pilot light are the last things to hook up. Title: Re: Is it just me? Post by: hywelg on August 22, 2009, 08:04:57 AM The label should have the voltages of the various taps which should allow you to correlate the wire colours to the layout drawing (post a pic maybe?). If it doesn't you'll need to email Nik because, for future reference (ie future owners and repairers maybe 40 years down the line when this is a cherished antique!) you really do need these labels.
Title: Re: Is it just me? Post by: djroge1 on August 22, 2009, 08:09:06 PM Here are some pics.
In the wire diagram one side reads from left to right: 6-0-60-0-3.15-0-3.15-E Mine reads from left to right: 3.15v-0-3.15v 230v-120v-100v-0- E The other side of the wire diagram reads left to right: 240-220-120-0 - - 345-0-345 Mine reads left to right: 50v-0-6v-0-345v-0-345v (http://i492.photobucket.com/albums/rr282/djroge1/IMG_0123_0130_edited-1-1.jpg) (http://i492.photobucket.com/albums/rr282/djroge1/IMG_0130_0135_edited-1.jpg) (http://i492.photobucket.com/albums/rr282/djroge1/IMG_0128_0133_edited-1.jpg) (http://i492.photobucket.com/albums/rr282/djroge1/IMG_0127_0132.jpg) Title: Re: Is it just me? Post by: hywelg on August 22, 2009, 09:33:08 PM OK, so yours are a little different, but they are the same as mine so here goes.
345-0-345 are purple - brown -purple these go to the diodes on the powersupply rectifier board, the '0' goes to HT fuse. 0-120-220-240 are the incoming supply group. 0 goes to the neutral of you mains socket and the wire matching your wall voltage goes to the mains switch, make the others safe and coil them out of the way. 3.15 - 0 - 3.15 are the heater supply, 0 to ground, 3.15's to the tag board and on to the heaters/filaments 6 - 0 this is the footswitch supply connect as per diagram to the footswitch voltage regulator board. 60 - 0 (OK yours says 50 but thats fine) this is the bias supply, connect the 50 to the board and the 0 to star ground. Title: Re: Is it just me? Post by: djroge1 on August 23, 2009, 05:22:32 AM Thanks! I'll give that try and see what happens and perhaps by this time tomorrow (my local 11:00pm) I'll have it hooked up.
|