|
Title: Finished my build but no reading on v1 & v2. Post by: cyndicate on June 05, 2010, 07:25:28 PM Just finished my 100w Bluesmaster HRM build, checking voltages right now and my Pin 5 looks like its reading way too high. Currently at ~-70 DC
Any suggestions/comments to what is wrong? Title: Re: Finished my build but my pin 5 is reading way too high.. Post by: cyndicate on June 05, 2010, 10:34:12 PM Ok did some trouble shooting with Nik and solved that problem, now I have another one. Not getting readings on V1 and V2 and it looks like the 15k Resistor on the power board is burnt out.
(http://img.photobucket.com/albums/v344/PeeMonkey/Ceriatone%20100w%20HRM%20Build/DSC_0144-1.jpg) Heres a picture. I don't have any spare 15K 2W resistors, but I do have a 22K 2W resistor, I noticed all the other Overtones use a 22k here, can I put a 22k here instead and get a 15k in there later? Title: Re: Finished my build but my pin 5 is reading way too high.. Post by: cyndicate on June 05, 2010, 10:55:11 PM Is this resistor really hot for anyone else?
Title: Re: Finished my build but no reading on v1 & v2. Post by: cyndicate on June 06, 2010, 04:43:28 AM Its reading ~-.4 on Pin 1 of V1 and -.19 on Pin 6, still have no clue what is wrong.
Title: Re: Finished my build but no reading on v1 & v2. Post by: cyndicate on June 06, 2010, 06:53:07 PM Found out the problem.. on the floating terminal strip with the 22uF cap, I accidentalyl wired M and the resistor to the middle lug (Ground)
|