Ceriatone Forum

I'm trying to get a head cab built with a space for a c-lator but I don't have my c-lator yet.

Was wondering if someone can give me accurate dimensions of their c-lator.

Thanks in advance.

Here's an old post where I measured mine for another forumite, refer to page 3 and 4

http://ceriatoneforum.com/index.php?topic=3569.msg18318#msg18318

I never measured from front to rear since it was not really necessary. The width is the same as OTS 19" with the flanges, the height is 1 3/4". I can measure the width minus flanges tonight and get back to you!

Todd

I was that forumite, and I 'll find out real soon if the measurements got me where I needed to go...

Thanks again Todd!!!!

Thanks Todd,

If you could measure the width minus the flanges that would be great.

I just want to be sure I have accurate measurements before I send them to the builder.

Thanks again,
Bob

Sure thing
I will post the measurements as soon as I get home from work.

Todd

OK the C-lator measurements are:

Width is 17 5/16" without flanges and 19" with them.
height is 1 3/4"
and is 7" deep.

So cutout should be 17 5/16 X 1 3/4

Hope this helps

Todd

Got your email, Bob, but Todd beat me to it (I'm still at work) just wanted you to know i wasn't ignorin ya! be sure to post pics when ya get it built!

Gregg

Thanks Todd,
I appreciate the measurements.

Hey Gregg,
No worries, I didn't think you were ignoring me.
After I sent you the email I thought it might be a good idea to post it here.

I'll be sure to post pics when I get it!