100R resistor on normal channel's tone to ground bus

hvrock13
Newbie

Offline

Posts: 3

100R resistor on normal channel's tone to ground bus

« on: July 26, 2010, 03:28:01 PM »

I just finished everything on my 18 watt TMB head, but one part of the layout confused me. On the normal channel, it shows a 100R resistor from the tone pot's middle prong to the ground bus. I have one left over resistor, but it doesn't look like a 100R. The rest of the resistors I double checked and they are all in their right places. What should I do? Is it okay to just leave out that resistor and just use a wire from that prong to the ground bus? I could go out and buy a resistor if it's needed though.

Oh and I was wondering, nik sent me a schematic similar to his layout but he said it wasn't the exact same, but could help a little. It doesn't show the diodes and the capacitor on the tube rectifier, but the layout on the ceriatone page for this amp does show them. Is it best I leave them in?

I'm new to all this.. First diy amp and I'm building with my dad.


	Logged

flight
Newbie

Offline

Posts: 2

Re: 100R resistor on normal channel's tone to ground bus

« Reply #1 on: August 12, 2010, 07:37:10 PM »

You can leave it out to get it up and running

I think it has something to do with the pots taper?

Edit: never read the post so it was flagged as 'new' Shocked


« Last Edit: August 12, 2010, 07:42:54 PM by flight »	Logged

Kitarist
Administrator
Sr. Member

Offline

Gender: Male

Posts: 253

Re: 100R resistor on normal channel's tone to ground bus

« Reply #2 on: August 23, 2010, 04:33:14 PM »

Yea the guy probably figured it out already Cheesy


	Logged

Music has to breathe and sweat. You have to play it live

arledgesc
Newbie

Offline

Posts: 29

Re: 100R resistor on normal channel's tone to ground bus

« Reply #3 on: November 08, 2010, 02:47:03 PM »

Without the 100 ohm resistor dialing the tone control all the way counterclockwise would shunt all the signal from this channel to directly to ground. And you would get little or no output. Addition of the resistor is meant to be a lower limit stop and prevent totally killing the channel when adjusting tone on the low end.


« Last Edit: February 20, 2012, 08:40:33 PM by arledgesc »	Logged

Ceriatone JTM50, 18W TMB, and C-lator
MetroAmp JTM45 and JMP50
Scumback M55 and M75 Speakers

Pages: [1]

« previous next »

	Welcome, Guest. Please login or register. Did you miss your activation email? November 27, 2024, 04:22:19 AM

News: Ceriatone Forums are up and running!!! Guests please register Note: If you want to help you can to keep the forums alive. Do you want to advertise on this forum ? Send me a private message.